Installation; Placement And Mounting - Ecler HAK360 Manual De Instrucciones

The new custom ECLER channel faders are combined to a high quality VCA process
which offers, in contrast to conventional faders, a much higher lifetime and the possibility to
modify and reverse the attenuation curve (Shape Adjustment for "Mixing" and "Scratching").
ECLER Laboratories did test the new ECLER fader lifetime up to 4.000.000 Operations !
The overall instrument features 2+2 mixable channels (channel one, channel two,
session, mic), with 5+1 stereophonic inputs and one microphone input (2 Phono, 2 Line, 1
Session, 1 Microphone). Two main channels feature a three band equalizer with full frequency
cut, a gain control, a balance slider, a new ergonomic channel CUT toggle switch, and PFL
function in order to display its level directly on the VU-meter and hear it through the
headphones.

3. INSTALLATION

3.1. Placement and mounting

The first thing to take into consideration when placing your HAK is your comfort and
an easy access to all the connections. The HAK360 is basically conceived as a tabletop mixer
and its usual placement will be between two vinyls or CD players. The optional metallic side
profiles kit allows you to firmly fix your HAK to the surface over which it is placed or over its
own profiles (Fig.1). These profiles also allow to tilt the mixer's position for an easier operation.
Because of the high gain of the PHONO and MICROPHONE inputs, always try to place
the mixer as far away as possible from noise sources (dimmers, engines, etc.) and mains wires.
For the very same reason, and under any circumstance, you should never remove the unit's
metallic cover.
The power consumption of the HAK is very low, so they don't need any cooling, but
you should avoid extreme temperatures and the atmosphere should be as dry and dustfree as
possible.
The HAK360 operates now with a new universal input power supply "Switching
Power Supply" and can perfectly works without any internal modification from 90V to 264V –
47 to 63Hz. Make sure that the mains-wire is far away from the signal-cables in order to avoid
any possible audio hum.
In order to protect the unit from an eventual electrical overload it carries a 500mA
fuse. Should it ever blow up, unplug the unit from mains and replace it with an identical one. If
the new fuse blows again contact immediately with our authorized technical service.
ATTENTION: NEVER SHORT-CIRCUIT THE SECURITY PATH NOR USE A HIGHER VALUE FUSE.
CAUTION: Fuse substitutions have to be performed by a qualified technician.
5