Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

minimum wire size. The following table shows the correct size to
use depending on cord length and nameplate ampere rating. If in
doubt, use the next heavier gauge. The smaller the gauge number,
the heavier the cord.
Minimum Gauge for Cord Sets
Volts
Ampere
120 V
25
Rating
(7.6)
240 V
50
(15.2)
More
Not
More
Than
Than
0
6
18
6
10
18
10
12
16
12
16
14
WARNING: ALWAYS use safety glasses. Everyday eyeglasses are
NOT safety glasses. Also use face or dust mask if cutting operation is
dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
Total Length of Cord
in Feet (meters)
50
100
150
(15.2)
(30.5)
(45.7)
100
200
300
(30.5)
(61.0)
(91.4)
AWG
16
16
14
16
14
12
16
14
12
12
Not Recommended
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disperse dust,
which may cause serious and permanent respiratory or other
injury. Always use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles away from face
and body.
WARNING: Always wear proper personal hearing protection
that conforms to ANSI S12.6 (S3.19) during use. Under some
conditions and duration of use, noise from this product may
contribute to hearing loss.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V .............. volts
Hz ............ hertz
min .......... minutes
....... direct current
............ Class I Construction
................
................
(grounded)
............ Class II Construction
................
(double insulated)
4
A ...........amperes
W ..........watts
........alternating current
........alternating or
.............direct current
n o .........no load speed
n ...........rated speed
..........earthing terminal

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

D25416D25430

Tabla de contenido