Set-Up; Shredding; Risk Of Injury - Easy Home PBS 14 Manual Del Usuario

Set-up

1. Place the base unit
upwards.
2. Install the castors
at the left side of the base unit. Push the castors downwards into the holes
on the base unit until they lock into place (see fig. B).
3. Turn the base unit over after the installation of the castors.
4. Install the main unit
downwards until it locks into place (see fig. C).
A loud click sound can be heard on each side when the main unit has been
securely installed.
5. Install the CD waste bin
(see fig. D).
6. Slide the paper / credit card waste bin into the base unit (see fig. E).
You must fully slide the paper / credit card waste bin into the base unit until
a click sound is heard. This indicates that the safety switch
deactivated for normal operation.
The paper shredder is now assembled. Please note that the base unit
should not be disassembled.
Set-up
1. Make sure that the paper shredder is switched off (slide switch
OFF position) before plugging it into a socket.
2. Connect the power cord
3. Set the slide switch to the AUTO position.
The paper shredder is now ready for use.

Shredding

WARNING!

Risk of injury!

Handling the paper shredder improperly may result in injury.
− Hold the paper by both sides when inserting into the feed
slot. Make sure that your fingers do not get too close to the
feed slot.
− Only hold the CD by the outer edge when inserting into
the feed slot. Make sure that your finger is not in the CD
hole, this can cause injury when the CD is drawn in.
14
14 upside down so that the bottom side is facing
10 at the right side and the castors with locking levers
5 on top of the base unit. Firmly push the main unit
12 in the paper / credit card waste bin
1 to a socket.
11
13
has been
6
4 at the