− Hold the credit card by its narrow side when inserting into
the feed slot. Make sure that your fingers do not get too
close to the feed slot.
NOTICE!
Risk of damage!
Improper handling of the paper shredder may result in damage
to the paper shredder.
− Do not operate the paper shredder for longer than
3 minutes without interruption. Allow it to cool down to
room temperature first before restarting operation.
− Do not feed damp paper into the feed slot. It could wrap
around the cutting unit and cause a blockage.
− Do not feed paper with paper clips. This could damage the
cutting unit.
− Do not feed more than 10 sheets of paper simultaneously
into the feed slot. This could damage the cutting unit.
• The paper shredder is equipped with a safety switch
• The paper shredder is equipped with a paper / credit card
which stops the operation of the paper shredder when
it is activated. The safety switch is activated when the
paper / credit card waste bin
base unit
14
or when the whole paper shredder is lifted up
with the handles
safety switch is activated or deactivated.
detection sensor
paper shredder switches on automatically only when you
insert paper or credit cards at the centre of the paper / credit
card feed slot
8
at the centre of the CD feed slot
The paper, credit card or CD is drawn in automatically after
activating the respective detection sensor.
If you feed in paper that is too thin (e.g. airmail, carbon copy
or tracing paper), the paper / credit card detection sensor
may not be activated. This is normal and not a defect. In this
case, do not feed in single sheets, but multiple sheets. Also
note that excessively thin paper is difficult to feed and can
thus more easily jam in the cutting unit.
is not fully inserted into the
13
7
. You will hear a click sound when the
and a CD detection sensor
9
. The same applies when you insert the CD
2
3
.
Shredding
6
. The
15