Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
VERSIONS AND ACCESSORIES
Apart from the basic version consisting of acoustic cabinets, amplifiers and the
processor unit, a complementary version is available for upgrading purposes: The EPC 6000C.
The only difference lies in the fact that this version does not include the EPC 200 processor, as
bigger systems need just one of these units.
It is also possible to fit all system electronics into a flight case (ref EPC FL). 10m
connection cables are included apart from the internal wiring and connection panel.
OTHER ACCESSORIES
EPP LINT This interconnection panel for EPCs lets you configure a EPC 6000 as a slave
(EPC 200 bypassed) or master device (EPC 200 working).
EPP AINT 15m multicore cable for interconnecting two EPP LINT or successive units.
WH 200 Kit consisting of 4 pivoting wheels for the EPC 200
3. INSTALLATION
3.1. Placement and mounting
The acoustic characteristics of the room, hall... and the number of assistants must be
taken into account. General rules valid for any case: place the acoustic cabinets on solid and firm
surfaces. The bass reinforcement cabinets are more efficient when are placed directly on the floor
in an oblong position rather than vertical or elevated or hanged. We recommend to place the bass
cabinets vertical for a better sound quality.
Be sure that there is not any obstacle between the mid-treble cabinets and the audience;
the high frequencies are extremely directive and any obstacle represents an attenuation. For a big
audience, the higher you place the mid-treble cabinets, the better sound propagation you will get.
Although all the EPC cabinets protect the loudspeakers with a grille and a foam do not expose the
system to the sun for long periods and avoid the rain.
The EPC200 operates (depending on country) under 110, 120, 220, 230 or 240V AC
50/60Hz. See characteristics in the back of the unit. You should avoid mixing the mains wire
with and in between shielded signal cables, because this could generate noise and hum.
In order to protect the mixer from eventual mains overloads or occasional excesses in
the consumption of the internal circuits, it has a 250mA (20) mains protection fuse. Should this
fuse ever blow off, disconnect the unit from mains and replace it for an identical one. If the
new fuse also blows ask our Authorised Technical Service. NEVER REPLACE THE FUSE WITH
ANOTHER ONE WITH A HIGHER VALUE.
CAUTION: Fuse substitutions have to be performed by a qualified technician.
7
Publicidad
Tabla de contenido
