Declaration Of Conformity - Beta 1934MAV Manual De Uso E Instrucciones

USE
Start / Stop
To start the micro grinder, turn the start control to ON (picture 3-e). After the job has been completed, turn the control back to OFF. The
micro grinder will stop within 5s.
The micro grinder is fitted with a rear air outlet through the tube guard (picture 1-b).
When the grinding wheel stops, place the micro grinder in a firm and safe position. The grinding wheel does not stop immediately.
Grinding wheel installation/replacement
Install the grinding wheel on the micro die grinder (picture 2) as follows:
– Loosen the spindle nut of the rotating grinding wheel spindle by means of the open end wrenches;
– Fit the grinding wheel into the chuck, and lock the nut by means of the open end wrenches. Only a 3-mm diameter of the grinding
wheel spindle will fit in;
– Make sure that the grinding wheel has been fixed correctly;
– The grinder can rotate in one direction only
Replace the micro die grinder wheel as follows:
– Loosen the spindle nut of the rotating grinding wheel spindle by means of the open end wrenches;
– The grinding wheel has thus been released and can be removed;
– Fit in the new grinding wheel and follow the above instructions.
Always disconnect the air supply before making adjustments or fitting in the grinding wheel. This precaution will prevent the
pneumatic tool from being accidentally started.
Lubrication/Greasing
The pneumatic tool must be connected to a filter-lubricator unit (we recommend Beta item 1919F1/4) provided with an air-oil microfog
mixer, set at two drops per minute. This will result in a high-performing tool and wear-resistant mechanical parts.
If lubrication is not provided to the line, oil ISO 32 must be periodically poured into the pneumatic tool, through the air supply hole
(picture 5-h).
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel only. For such jobs, you can contact Beta Utensili S.P.A.'s repair
centre through your Beta dealer.
DISPOSAL
The pneumatic tool, accessories and packaging should be sent to a waste disposal centre, in accordance with the laws in force in your
country.
WARRANTY
This tool is manufactured and tested in accordance with current EU regulations, and is covered by a 12-month warranty for professional
use or a 24-month warranty for nonprofessional use.
We will repair any breakdowns caused by material or manufacturing defects by fixing the defective pieces or replacing them at our
discretion.
Should assistance be required once or several times during the warranty period, the expiry date of this warranty will remain unchanged.
This warranty will not cover defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition, this warranty will no
longer be valid if any changes are made, or if the pneumatic tool is forced or sent to the customer service in pieces.
This warranty explicitly excludes any damage to people and/or things, whether direct or consequential.
We hereby declare, assuming full responsibility, that the described product complies with all the relevant provisions of Machine
Directive 2006/42/EC and amendments thereto, as well as with the following standard:
• EN ISO 11148-9
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18 - 20845 Sovico (MB) - ITALY
Name and title of person in charge
MASSIMO CICERI
(Managing Director)
BETA UTENSILI S.P.A.
Via A. Volta 18
20845 Sovico (MB)
ITALY
(clockwise).

DECLARATION OF CONFORMITY

Date 01/01/2015