5.2.2 Menu BASIC – Basic Application
Seq
Indication on the Display / Action
1
Monitoring mode. Press the key ENTER/
„
M E N U to e n te r t h e 1
programming mode.
3
When the BASIC group is selected press
„
the key ENTER/MENU.
5
If necessary, modify the content of "P0101
„
– Deceleration Time".
Press the key
„
7
If necessary, modify the content of "P0134
„
– Maximum Speed".
Press the key
„
9
To end the Start-up routine, press the key
„
BACK/ESC.
To return to the monitoring mode, press the
„
key BACK/ESC again.
l e ve l of t h e
s t
for the next parameter.
for the next parameter.
Figure 5.4: Sequence of the basic application group
Powering up and Startup
Seq
Indication on the Display / Action
2
The PARAM group is selected, press the
„
keys
or
group.
4
Basic Application routine is started. If
„
necessary, modify the content of "P0100 –
Acceleration Time".
Press the key
„
6
If necessary, modify the content of "P0133
„
– Minimum Speed".
Press the key
„
8
If necessary, modify the content of "P0135
„
– Maximum Output Current".
Press the key
„
until selecting the BASIC
for the next parameter.
for the next parameter.
for the next parameter.
CFW500 | 33