Operation; Hold-Dimmer Mode; Hold-Sound Mode; Prog-Sound Mode - EuroLite LCD-4 Manual Del Usuario

Analog output
Connect analog power packs via the 8-pin DIN-socket. The occupation is as follows:

6. OPERATION

After you connected the device to the mains, the LCD-4 is ready for use.

6.1 Hold-Dimmer Mode

Call spots manually:
In the Hold Dimmer Mode, the connected spots can be called manually and be controlled via the channel
faders.
Adjust the desired function via the channel faders.
1. Turn controller ON
2. Press Mode Select until Hold Dimmer LED is illuminated
3. Adjust channel faders
4. Adjust dimmer fader for total output
This function is useful for theatres and booth illumination.

6.2 Hold-Sound Mode

Spots as light organ:
In this mode, the LCD-4 works as light organ. Every channel is assigned to a special frequency. The spots
reacts in accordance to the music level. Additionally, the Flash-buttons can be used..
1. Turn controller ON
2. Press Mode Select until Hold Sound LED is illuminated
3. Adjust dimmer fader for total output
4. Adjust Audio fader until the spots react to the sound signal
This function is designed for entertainers and party rooms.

6.3 Prog-Sound Mode

Spots run sound-controlled through internal programs:
In this mode, all 42 programs of the LCD-4 can be run sound-controlled.
You can manually adjust the individual channels via the channel faders, the dimmer fader and via the flash-
buttons.
1. Turn controller ON
2. Press Mode Select until Prog Sound LED is illuminated
3. Adjust dimmer fader for total output
4. Adjust Audio fader until the spots react to the sound signal
5. Select the desired program via the Prog Select-button. The program numbers are called up from low to
high. You can invert the program selection by pressing and holding the Prog Select-button and pressing
the Mode Select-button.
This function is designed for discotheques.
16/30 70064590_V_1_5.DOC