Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Power: to switch the unit on and off.
Speed: to control the flash speed.
Auto/Manual/Audio: for manual operation.
Channel: to switch each channel on and off.
Trigger: for manual flashing.
Mode: to select if both channels should flash at the same time or one after another.
Delay: to select when the next stroboe should flash. After every flash (1), after every second flash (2), after
th
every 4
flash (4) or after every 8
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rearpanel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
th
flash (8).
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
13/24
00026750.DOC, Version 1.3
Publicidad
Tabla de contenido
