Hanging The Fan - Progress Lighting AirPro P2570 Manual De Instalación

Hanging the Fan

REMEMBER to turn off the power. Follow the
steps below to hang your fan properly.
NOTE: This ceiling fan is supplied with two types
of hanging assemblies; the standard ceiling
installation using the downrod with ball and socket
mounting, and the "close-to-ceiling" mounting.
The "close-to-ceiling" mounting is recommended
in rooms with less than 8-foot ceilings or in areas
where additional space is desired from the floor to
the fan blades.
When using the standard downrod installation, the
distance from the ceiling to the bottom of the fan
blades will be approximately 18 1/8 inches. The
"close-to-ceiling" installation reduces the distance
from the ceiling to the bottom of the fan blades to
approximately 9 inches.
Once you have decided which ceiling installation
you will use, proceed with the following
instructions. Where necessary, each section of the
instructions will note the different procedures to
follow for the two types of installation.
Option 1:
Standard Ceiling Mounting
Remove the canopy ring from the canopy.
1.
(Figure 5)
Remove the
Canopy Ring
Remove the mounting bracket from the canopy
2.
by loosening the four screws on the top of the
canopy. Remove the two non-slotted screws
and loosen the slotted screws. (Figure 6)
Loosen but
do not Remove
Route wires exiting from the top of the fan
3.
motor through the coupling cover, decorative
scroll, canopy cover, canopy ring, canopy and
then through the ball/ downrod. (Figure. 7)
Loosen, but do not remove the 2 set screws on
4.
the collar on top of the motor housing.
Motor Wires
Ball/Downrod
Assembly
Ceiling Canopy
Canopy Ring
Canopy Cover
Figure 5
Decorative Scroll
Motor Collar
Remove
Clevis Pin
5. Align the holes at the bottom of the downrod
with the holes in the coupling on top of the
motor housing. (Figure 7) Carefully insert the
clevis pin through the holes in the collar and
downrod. Be careful not to jam the clevis pin
Figure 6
against the wiring inside the downrod. Insert
the cotter pin through the hole near the end of
the clevis pin until it snaps into its locked
position, as noted in the circle inset of Fig. 7.
6.
Tighten two set screws on top of the fan motor
firmly. Attach the decorative scroll to the
motor housing using the screws provided.
(Figure 7)
Screws
Coupling Cover
Tighten Screw
Firmly
Cotter Pin
Figure 7
4.