Hanging The Fan - Progress Lighting AirPro COPAN Manual Del Usuario

Hanging the Fan

REMEMBER to turn off the power. Follow the
steps below to hang your fan properly:
Step 1.Route the wires exiting the top of the fan
motor through the cover (D) and then through
the canopy (C) , downrod (B) and
assembly.(Fig.5)
Figure 5
Step 2. Insert the downrod (B) through the metal
cover (D) and canopy (C). (Fig 6)
Step 3. Insert the end of downrod (B) through
the connector (PP),align the two holes in the
downrod (B) and the connector (PP).(Fig.6)
Step 4. Insert a plug pin (GG) through the two
holes in the downrod (B) and the connector (PP).
(Fig.6)
Step 5. Insert the R-shaped pin (HH) though the
hole near the end of the plug pin (GG) until it
snaps into its locked position. (Fig.6)
Step 6.Install the screws (FF) to the connector
(PP), and make sure it's tighten.Screws(FF)
should be tight against the downrod (B). (Fig.6)
hanger ball (J)
Step 7. Insert the hanger ball (J)
downrod (B), and then insert a plug pin (L)
through the hole in the downrod (B). (Fig.7)
Step 8. Insert the plug pin to the slot cut off in
the hanger ball (J) until it snaps into its locked
position. (Fig.7)
Step9.Use the Screw(K) to lock the hanger ball
(J) to the downrod (B). (Fig.7)
Figure 7
Step 10. Install the Hanger bracket (A) on the
outlet box by using the washer (BB) and
screws(AA) provided with the
Step 11. Put the hanger ball (J) through the open
side of the ceiling mounting bracket (A), and
then insert the hanger ball(J) to the slot cut off in
the ceiling mounting bracket(A). (Fig.8)
Figure 6
onto the
Figure 8
box. (Fig.8)
Outlet
4.