Switching On/Off; Replacing Blades - HAIRCUT TH37 Manual De Utilización

PROFESSIONAL CORD CLIPPERS
EN
3. Use

3.1. Switching on/off

When first used, lubricate the blades by applying a drop of oil to the points
shown (Fig. 4).
 Connect the power cord (Fig. 1-E) to a mains power socket.
 Switch the clippers on by pressing the On/Off button (Fig. 1-B).
 After use, stop the clippers and disconnect the electrical lead.
3.2. Adjusting the cutting height with the lever
The cutting height can be adjusted during use of the clippers, with the adjusting
lever (Fig. 1-C):
 Push the lever upwards to reduce the cutting height.
 Push the lever downwards to increase the cutting height.
3.3. Using the comb attachments
 The clippers
(Fig. 1 refs. F-K).
 Place the comb attachment on the blades and clip in at the rear. When the
comb attachment is correctly fixed, it is immobilized.

3.4. Replacing blades

 Switch the clippers off and unplug the unit from the mains power supply.
 Take the screws out of the blades (Fig. 3) and remove the upper and lower
cutters.
During their assembly, the upper and lower cutters must be aligned as instructed
below:
 Set the adjusting lever to the minimum cutting height.
 The distance between the front edge of the lower cutter and the front edge of
the upper cutter must be between 0.8 mm and 1.5 mm.
 The upper and lower cutters must be set parallel.
 The end tooth on the upper cutter (on the left-hand end) must cover the end
tooth on the lower cutter.
 The other end tooth on the upper cutter (on the right-hand end) must also
touch the corresponding end tooth on the lower cutter (on the right-hand end).
 Tighten the two screws (Fig. 3).
must be switched off. Select
19
a comb attachment