Replacing The Lamp; Closing The Door - Electrolux REX FI1501 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

10 www.electrolux.com
Problem
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.

7.1 Replacing the lamp

1.
Disconnect the mains plug from the
mains socket.
2.
Remove the screw from the lamp
cover.
3.
Remove the lamp cover (refer to the
illustration).
4.
Replace the used lamp with a new
lamp of the same power and specifi-
cally designed for household applian-
ces. (the maximum power is shown
on the lamp cover).
5.
Install the lamp cover.
6.
Tighten the screw to the lamp cover.
7.
Connect the mains plug to the mains
socket.
8.
Open the door. Make sure that the
lamp comes on.
Possible cause
There is too much water in
the air deflector.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.

7.2 Closing the door

1.
2.
3.
Solution
Clean the air deflector.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product tempera-
ture decrease to room tem-
perature before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Clean the door gaskets.
If necessary, adjust the door. Refer to
"Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.

Publicidad

Tabla de contenido
loading

Tabla de contenido