Disc Playback; Usb Device Playback - Yamaha TSX-112 Manual De Instrucciones

Ocultar thumbs Ver también para TSX-112:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 102
TROUBLESHOOTING

Disc playback

Problem
Disc cannot be inserted.
Some button operations
do not work.
Playback does not start
immediately after
pressing
.
"No Disc" or "Unknown
Disc" is displayed in the
front panel display after
loading a disc.

USB device playback

Note
In case of a transmission error without a status message appearing in the front panel of this unit, check the
connection to the USB device (☞ P. 7).
Status message
USB Unplugged
Unknown USB
Over Current
No Files
USB Time Out
Problem
MP3/WMA file in the USB
device does not play.
16
En
Cause
The system is set to power save mode (☞ P. 2). Set CLOCK to ON on the rear panel to
The disc loaded into the unit may not be
compatible.
The disc may be dirty.
The disc loaded into the unit may not be
compatible.
If the unit was moved from a cold to warm
place, condensation may have formed on the
disc reading lens.
The disc loaded into the unit may not be
compatible.
The disc may be dirty.
The disc is loaded back to front.
The disc does not contain playable files.
An error occurs in the unit.
Cause
The USB device is not connected firmly.
The connected USB device is not playable on
this unit.
The file name is too long.
The USB device is connected at an angle.
The USB device does not contain playable
files.
An incompatible USB device is connected to
the unit.
The number of files/folders exceeds the
limit.
Cause
The USB device is not recognized.
Solution
cancel power save mode (☞ P. 4).
Use a disc supported by the unit (☞ P. 17).
Wipe the disc clean.
Use a disc supported by the unit (☞ P. 17).
Wait for an hour or two until the unit adjusts
to the room temperature, and try again.
Use a disc supported by the unit (☞ P. 17).
Wipe the disc clean.
Insert a disc facing the label side to near side.
Use a disc contains playable files (☞ P. 17).
Unload the disc with
.
Remedy
Connect the USB device again (☞ P. 7).
Connect playable USB device (☞ P. 17).
The file name should be no more than 250
characters.
Disconnect the USB device and then turn the
system off and on again. Then connect
playable USB device again (☞ P. 17).
Use a USB device contains playable files
(☞ P. 17).
Turn off the system and reconnect the USB
device to the unit. If it does not resolve the
problem, the USB device is not playable on
the unit.
Reduce the number of files/folders; refer to
the limitations noted in this manual (☞ P. 17).
Solution
Turn off the system and reconnect the USB
device to the unit.
Connect an AC adapter if supplied with the device.
Format the USB device and copy the files again.
If the solutions above do not resolve the problem,
the USB device is not playable on the unit.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido