Ipod; Disc Playback - Yamaha TSX-130 Manual De Instrucciones

Ocultar thumbs Ver también para TSX-130:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 124
TROUBLESHOOTING

iPod™

Problem
"iPod Connect Error"
appears on the front panel
display.
The iPod does not charge
up.
"iPod Not Connected"
appears on the front panel
display after you set the
iPod.
The iPod makes no sound.
The iPod sounds, but you
cannot operate it with the
unit or the remote control.
You cannot operate from the
iPod.
The playback information is
not displayed on the front
panel display.
"Unknown iPod" appears on
the front panel display after
you set the iPod.

Disc playback

Problem
Some button operations do
not work.
Playback does not start
immediately after pressing
6
on the unit or
remote control.
"No Disc" appears in the
display even though a disc
is in the disc tray.
18
En
There is a problem with
communication between the unit and
your iPod.
The iPod is set in the iPod dock
improperly.
LIST DISP is set to F.PANEL.
The iPod you set is not compatible
with the playback information
display.
The iPod being used is not supported
by the unit.
The disc loaded into the unit may not
be compatible.
The disc may be dirty.
The disc loaded into the unit may not
on the
be compatible.
If the unit was moved from a cold to
warm place, condensation may have
formed on the disc reading lens.
The disc loaded into the unit may not
be compatible.
The disc may be dirty.
Disc is loaded upside-down.
Cause
Cause
Solution
Turn off the system and reconnect your
iPod to the unit.
Remove the iPod from the unit, then set
it in the iPod dock again.
Set LIST DISP to iPod from the
FUNCTION menu (☞ P. 11).
Only iPod touch, iPod classic, iPod 5
generation or later, and iPod nano are
compatible with the function.
Only iPod touch, iPod (Click Wheel,
including iPod classic), iPod nano and
iPod mini are supported.
Solution
Remove the disc and then check whether
the unit supports the disc or not
(☞ P. 20).
Wipe the disc clean.
Use a disc supported by the unit
(☞ P. 20).
Wait for an hour or two until the unit
adjusts to the room temperature, and try
again.
Use a disc supported by the unit
(☞ P. 20).
Remove the disc and then wipe the disc
clean.
Remove the disc and then load the disc
with the labeled side facing up.
th

Publicidad

Tabla de contenido
loading

Tabla de contenido