Usb Device Playback; Radio Reception; Remote Control - Yamaha TSX-140 Manual De Instrucciones

USB device playback

Problem
MP3/WMA file in the USB
device does not play.
Flashing USB indicator twice
is repeated 3 times after
connecting a USB device.
"Err" is displayed in the front
panel display after
connecting a USB device.

Radio reception

Problem
Too much noise during
stereo broadcast.
Even with an outdoor
antenna, radio wave
reception is weak. (Sound is
distorted.)

Remote control

Problem
The remote control does not
work properly.
Cause
The USB device is not recognized.
An incompatible USB device is
connected to the unit.
The USB device does not contain
playable files.
An incompatible USB device is
connected to the unit.
An overcurrent is detected.
Cause
The antenna may be connected
improperly.
The radio station you selected may be far
from your area, or the radio wave
reception is weak in your area.
Multipath reflection or other radio
interferences may have occurred.
Cause
The remote control may be operated
outside its operation range.
The remote control sensor on the unit
may be exposed to direct sunlight or
lighting (inverted fluorescent lamps).
The battery may be worn out.
There are obstacles between the sensor of
the unit and the remote control.
TROUBLESHOOTING
Solution
Turn off the system and reconnect the USB
device to the unit.
Connect an AC adapter if supplied with the
device.
If the solutions above do not resolve the
problem, the USB device is not playable on
the unit.
Turn off the system and reconnect the USB
device to the unit. If it does not resolve the
problem, the USB device is not playable on
the unit.
Use a USB device contains playable files
(☞ P. 16).
Turn off the system and reconnect the USB
device to the unit. If it does not resolve the
problem, the USB device is not playable on
the unit.
Solution
Make sure the antenna is connected
properly (☞ P. 4).
Try manual tuning to improve the signal
quality (☞ P. 8) or use a multi-channel
outdoor antenna.
Change the height, direction, or placement
of the antenna.
Solution
For information on the remote control
operation range, refer to "Using the remote
control" (☞ P. 1).
Change the lighting or orientation of the
unit.
Replace the battery with a new one.
Remove the obstacles.
15
En