Working Techniques - Efco DS 2400 H Manual De Instrucciones

OPERATION

Working Techniques

General Working Instructions
WARNING: Do not cut during periods of high wind or
heavy precipitation.
WARNING: Never cut, when visibility is poor or in very
high or low temperatures or in freezing weather.
WARNING - Always wear the harness. Be careful not to
touch the gearbox housing after operation; THESE ARE
HOT ENOUGH TO CAUSE BURNS.
WARNING: Long-term exposure to noise can result in
permanent hearing impairment. So always use approved
hearing protection.
WARNING: Faulty blades can increase the risk of
accidents.
WARNING - If correctly used, the hedge trimmer is a
quick, easy to handle and efficient tool; if used
improperly or without the due precautions it could
become a dangerous tool. THE MACHINE CAN CAUSE
SERIOUS INJURY. For pleasant and safe work, always
strictly comply with the safety rules that follow and
throughout this manual.
• Check the cutting attachment. Never use blades that are dull,
cracked or damaged.
33
• Check that the machine is in perfect working order. Check that all
nuts and screws are tight.
WARNING: The complete clutch cover and gear housing
must be fitted before the machine is started, otherwise
the clutch may come loose and cause personal injury.
WARNING: If you encounter a situation where you are
uncertain how to proceed you should ask an expert.
Contact your dealer or your service workshop.
Avoid all usage which you consider to be beyond your
34
capability.
• When the engine is switched off, keep your hands and feet away
from the cutting attachment until it has stopped completely.
• Watch out for stumps of branches that can be thrown out during
cutting.
• Do not cut too close to the ground. Stones and other objects can be
thrown out.
• Check the working area for foreign objects such as electricity
cables, insects and animals, etc, or other objects that could damage
the cutting attachment, such as metal items.
• If any foreign object is hit or if high vibrations occur stop the
34
machine immediately. Disconnect the HT lead from the spark plug.
Check that the machine is not damaged. Repair any damage.
en
17