Troubleshooting - Bionaire BCH001X Manual De Instrucciones

To return your used device, please use the return and
collection systems or contact the retailer where the
product was purchased. They can take this product
for environmental safe recycling.
Jarden Consumer Solutions (Europe) Limited
5400 Lakeside
Cheadle Royal Business Park
Cheadle
SK8 3GQ
UK
INSTALLATION OF A PLUG (UK / IRELAND ONLY)
If the plug is not suitable for the socket outlets in your
home, it can be removed and replaced by a plug of
the correct type.
If the fuse in a moulded plug needs to be changed,
the fuse cover must be refitted. The appliance must
not be used without the fuse cover fitted.
If the plug is unsuitable, it should be dismantled and
removed from the supply cord and an appropriate
plug fitted as detailed. If you remove the plug it must
not be connected to a 13 amp socket and the plug
must be disposed of immediately.

TROUBLESHOOTING

PROBLEM CAUSE
Heater does not User reset is required.
turn on.
Unit not plugged in properly.
Temperature set too low.
Obstruction causing heater not to work.
Not enough heat. Heater set to Low.
Temperature set too low.
Heater cycles on The thermostat automatically turns the heater on
and off frequently. and off to maintain selected comfort level.
Heater is blowing Mode control is set to fan only setting.
cold air.
Unexpected noise. Popping or crackling sounds as the heater heats
up are normal and safe. Once the heater heats
up, the sound will go away.
Unexpected smell. There may be an odour coming from the heater
the first time you use it or after prolonged
storage.
If the terminals in the plug are not marked or if you
are unsure about the installation of the plug please
contact a qualified electrician.
This symbol indicates that this unit is a
Class II appliance and therefore an earth
connection is not required.
Plug should be ASTA approved to BS1363
Fuse should be ASTA approved to BS1362
Do Not Connect
Mains Wires Here
Blue
(Neutral)
Ensure that the outer sheath of
the cable is firmly held by the cord grip
SOLUTION
Follow the instructions described in the 'Auto
Safety Shut Off' section of this manual.
Ensure that the plug is correctly inserted. Make
sure outlet is working.
Select a higher temperature setting.
Keep any object at least 50cm away from the top,
back and sides and at least 200cm away from the
front grill.
Change setting to High.
Select a higher temperature.
To make this occur less frequently select a higher
temperature setting.
Select the Low or the High heat setting.
If the noise persists please call local Bionaire
service reprensentative.
Dust or other debris has accumulated on the
heating element. Make sure the heater is in a well
ventilated area and continue running it until the
odour goes away.
7
13A
Fuse
Brown
(Live)