Bosch GSR 1080-LI Professional Instrucciones De Servicio página 17

Instructions Manual
► Hold the machine with a firm grip. High reaction torque
can briefly occur while driving in and loosening screws.
► Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more secure than by
hand.
► Keep your workplace clean. Blends of materials are
particularly dangerous. Dust from light alloys can burn or
explode.
► Do not open the battery. Danger of shortcircuiting.
Protect the battery against heat, e. g., against
continuous intense sunlight, fire, water, and
moisture. Danger of explosion.
Battery tols use and care
► In case of damage and improper use of the battery,
vapours may be emitted. Provide for fresh air and
seek medical help in case of complaints. The vapours
can irritate the respiratory system.
► Recharge only with the charger specified by the manu-
facturer. A charger that is suitable for one type of battery
pack may create a risk of fire when used with another bat-
tery pack .
► Use power tools only with specifically designated bat-
tery pack. Use of any other battery packs may create a risk
of injury and fire.
► When battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys, nails,
screws or other small metal objects, that can make a
connection from one terminal to another. Shorting the
battery terminals together may cause burns or a fire.
► Under abusive conditions, liquid may be ejected from
the battery: avoid cotact. If contact accidentaly occurs,
Symbols
The following symbols are important for reading and understanding the operating instructions.Please take note of the symbols
and their meaning. The correct interpretation of the symbols will help you to use the machine in a better and safer manner.
F 000 622 336 | 06.2011
flush with water If liquid contact the eyes additionally
seek medical help. Liquid ejected from the battery may
cause irritation or burns.
Additional Safety and Working Instructions
► Dusts from materials such as lead-containing
coatings, some wood types, minerals and metal can be
harmful to one's health and cause allergic reactions,
lead to respiratory infections and/or cancer. Materials
containing asbestos may only be worked by specialists.
– Provide for good ventilation of the working place.
– It is recommended to wear a P2 filterclass respirator.
Observe the relevant regulations in your country for the
materials to be worked.
► Before any work on the machine (e. g., maintenance,
tool change, etc.) as well as during transport and
storage, set the rotational direction switch to the
centre position. Unintentional actuation of the On/Off
switch can lead to injuries.
► The battery is supplied partially charged. To ensure
full battery capacity, completely charge the battery in
the battery charger before using for the first time.
► The battery is equipped with a NTC temperature
control which allows charging only within a
temperature range of between 0 °C and 45 °C. A long
battery service life is achieved in this manner.
► Read the operating instructions of the battery
charger.
► Apply the power tool to the screw only when it is switched
off. Rotating tool inserts can slip off.
► Adjust the gear switch only when the machine is at a
complete stop.
► Always push the gear selector and turn the operating
mode selector switch through to the stop. Otherwise,
the machine can become damaged.
17
English |
Robert Bosch Ltda.