Meta System Meta Voice Manual De Uso página 8

Always refer to the operating manual for your mobile phone for details how to
pair up devices.
Once the mobile phone has located the device, identifi ed with the name MetaVoice,
enter 1234 when the link up code is requested.
The mobile phone display will show information relating to the pairing and connection
will be made based on the typical settings of each model of mobile phone.
The system is able to hold up to 4 paired devices (mobile phones / hands free sets) in
operation, it is not necessary to repeat the pairing procedure for the last 4 paired mobi-
les phones every time you switch the vehicle's dashboard, or the telephone, on or off .
Once 4 mobile phones have been paired up, it is still possible to recognise an additional
mobile phone, but this will take the place of the phone less recently recognised.
Recognition
Recognition: procedure for physically recognising the devices without the use of wires
so the system is able to work (MetaVoice module + gsm phone).
Recognition after the key contact has been switched on and any subsequent recogni-
tion, is signalled by 1 tone issued by the loudspeaker and the LED, which remains lit
without fl ashing. Once recognition has been established, the hands free set can be
used.
Recognition takes place with one of the mobile phones previously "paired up" with the
MetaVoice module, provided this has also been switched on and is within the "range"
of the system (5 meters). Should TWO (or more) "paired" mobile phones be in range
when the key contact is switched on, only ONE of the two (or more) will be recognised
according to the order of priority stored by the device.
The way the system operates depends on the type of mobile phone used.
Always refer to the operating manual for more detailed information.
Please note, in particular, that some types of mobile phone require you to enable au-
tomatic reconnection of the hands free set, whilst this operating mode is always active
with other models.
Voice calls
To place voice calls, this function must be supported by the type of mobile phone you
are using.
Always refer to the operating manual for your mobile phone for instructions how
to store voice tags.
Voice call mode is activated by pressing and holding the button down.
Access to voice call mode is signalled diff erently depending on the type of mobile pho-
ne you are using. Always refer to the operating manual for your mobile phone.
Once you have pronounced the voice tag for the number to call, it is repeated (provided
it has been identifi ed correctly) and the call is then placed. If not, you will get the reco-
gnition failure signal, which depends on the type of mobile phone you are using.
However, use of the mobile phone's keypad is always a preferable method for placing
calls.
8