Control Panel - Astralpool PC 2000 Manual De Instrucciones

3___CONTROL PANEL

3.1 GENERAL DESCRIPTION OF THE KEYPAD
This key displays the set points entered, in sequence. If
this function is enabled, the key can be used to change
the set-point value. Used together with the ACK key
enables the status of the set-point relays to be forced.
When this key is pressed, the wording ProG will be
displayed. If it is held down for 5 seconds, the instrument
will go into the programming mode. If the key is inhibited
by the protection implemented on the terminal strip, the
indication dlS will appear when it is pressed.
When the programming mode is entered, each time this
key is pressed programming will move forward by one
step.
This moves back through the programming steps. If it is
held down for 5 seconds, the instrument will exit the
programming function, and all the data will be permanently
stored.
It resets the alarm relay, however if the alarm status
persists the corresponding LED will stop flashing and
remain steady on until the cause of the alarm has been
eliminated. It will eliminate an error message and resets
the incorrect datum to the default value.
Pressing this key will increment the value displayed while
programming. Pressing it will also increment the value
displayed by pressing the SET key.
It causes the reference temperature ( manual or automatic
) to be displayed. If the temperature is manual it should be
pressed together with the DOWN key.
This key can be used to change the temperature value. It
decrements the value being displayed while programming.
It decrements the value displayed on pressing the SET
key.
It enables the manual function, and if it is pressed at the
same time as the SET key, it can be used to force the
relays controlling the pumps in the manual mode.
This key enables the Calibration menu to be entered.
5