Box Contents; Product Use; Working Principles - Greencut MMG185 Manual De Instrucciones

58

BOX CONTENTS

This machine includes the following items which you will find inside the box:
-
1x Welder
-
1x Ground cable
-
1x Electrode clamp cable
-
1x Torch
-
1x Welding mask
-
1x Brush/brush
-
1x Bearing
-
2x Nozzles
-
1x Instruction manual
• Remove the product and accessories from the box. Make sure all items are present.
• Inspect the product to ensure that it has not been broken or damaged in transit.
• Do not discard the packaging material until you have carefully inspected and satisfactorily used the product.
ATTENTION: If any part is missing or damaged, contact the Official Technical Service. Do not use
this product without having replaced the missing or damaged part. Using this product with
damaged or missing parts can cause serious injury to the operator.

PRODUCT USE

WORKING PRINCIPLES

The operating principles of the welding machine are shown in the following figure. Single-phase with 220V AC
working frequency rectified to DC (350V); then converted to AC frequency (about 40KHz.) via the inverter device
(IGBT).
After reducing the voltage through the transformer (main transformer) and rectifying through the rectifier (fast
recovery diodes), inductance filtration is emitted.
The circuit adopts current feedback control technology to ensure stable current output when in MMA or TIG mode .
It also adopts voltage feedback control technology to ensure stable voltage output when in MIG mode.
The welding current parameter can be continuously and infinitely adjusted to meet the requirements of the welding
job.