Box Contents; Product Use - Greencut MTC170 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

48

BOX CONTENTS

This machine includes the following items which you will find inside the box:
-
1x Welder
-
1x Welding mask
-
1x Brush with ice pick
-
1x Ground cable
-
1x Torch
-
1x Instruction manual
Remove the product and accessories from the box. Make sure all items are present.
Inspect the product to ensure that it has not been broken or damaged in transit.
Do not discard the packaging material until you have carefully inspected and satisfactorily used the product.
ATTENTION: If any part is missing or damaged, contact the Official Technical Service. Do not use
this product without having replaced the missing or damaged part. Using this product with
damaged or missing parts can cause serious injury to the operator.

PRODUCT USE

INSTALLATION
ENTRY CABLE CONNECTION
1.
The power cord located on the back of the welder is connected to a 220V AC power supply; make no
mistake in your connection.
2.
Connect the welder to ground with a cable which cross-section is not less than 2.5mm2 from the ground
screw located on the back of the welder to the ground connection of the junction box.
Electric power supply cable
Connection of the welder to ground
Connection to the material (ground)
TIG welding torch
Electrode holder
Gas supply hose

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido