Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
12. Environmental Protection
The sanding dust generated may contain
hazardous materials: do not dispose of this dust
with household waste, but at a special collection
point for hazardous waste.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
13. Technical specifications
Explanation of details on page 3. Subject to change
in line with technical advances.
D
= max. diameter of accessory
max
t
= Max. permitted thickness of clamping
max,1
shank on accessory when using
clamping nut (7)
M
= Spindle thread
l
= Length of the grinding spindle
n*
= No-load speed (maximum speed)
I
= Current at 120 V
120 V
P
= Nominal power input
1
P
= Power output
2
m
= Weight without mains cable
* Energy-rich, high-frequency interference can
cause fluctuations in speed. However, the fluctua-
tions disappear as soon as the interference fades
away.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
Using these values, you can estimate the
emissions from this power tool and compare these
with the values emitted by other power tools. The
actual values may be higher or lower, depending on
the particular application and the condition of the
accessory or power tool. In estimating the values,
you should also include work breaks and periods of
low use. Based on the estimated emission values,
specify protective measures for the user - for
example, any organisational steps that must be put
in place.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a
= Vibration emission level
h, S
(grinding)
K
= Uncertainty (vibration)
h,...
Wear ear protectors!
ENGLISH en
9
Publicidad
Tabla de contenido
