Filters; Important; Replacement Filter - Hoover HUSHTONE 6Q BACKPACK Manual Del Usuario

Filters

WARNING
TO REDUCE THE RISK OF PERSONAL INJURY – UNPLUG BEFORE CLEANING OR SERVICING. DO NOT
OPERATE VACUUM WITHOUT BOTH INLET FILTER AND FINAL FILTERS IN PLACE.
HEPA MEDIA FINAL FILTER
The final filters assist in the filtration process to return cleaner air to the room. There are 2 HEPA
Filters, one on each side of the backpack.
1 2
Remove filter door
by pulling rear tab
forward and rotating
out.

IMPORTANT

ALLOW FILTER TO DRY COMPLETELY BEFORE REPLACING. DRY FILTER ON EDGE SO AIR CIRCULATES
ON BOTH SIDES OF FILTER. THIS MAY TAKE UP TO 24 HOURS.

REPLACEMENT FILTER

Inspect HEPA Media Final Filter every month, rinsing when necessary. Check for
wear of media and replace if pleats are damaged. Change filter regularly to maintain
maximum performance.
Part No. 440009096
16
3
Pull filter out by the To replace filter door,
frame. Hand rinse in align the two forward
cold water under low facing tabs and rotate
pressure. Rinse only into place. Press rear
surface facing inside tab until door snaps
of machine. Allow to into place.
dry and reposition into
filter housing.
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY – UNPLUG BEFORE CLEANING OR SERVICING. DO NOT
OPERATE VACUUM WITHOUT BOTH INLET FILTER AND FINAL FILTERS IN PLACE.
HEXAGUARD ™ ACTIVATED
CARBON FILTER
1
The HexaGuard Filters are
™
located on the inside of the filter
door. Pull to remove.
IMPORTANT
ALLOW FILTER TO DRY COMPLETELY BEFORE REPLACING. DRY FILTER ON EDGE SO AIR CIRCULATES
ON BOTH SIDES OF FILTER. THIS MAY TAKE UP TO 24 HOURS.
REPLACEMENT
FILTER
Replace HexaGuard
™
Filter yearly for optimum
performance.
Part No. 440009176
LUBRICATION
The motor is equipped with bearings which contain sufficient lubrication for its lifetime.
The addition of lubrication could cause damage. Do not add lubrication to motor.
INLET FILTER
The inlet filter is located on the inside,
bottom of bag housing and protects
the motor from damage.
1
If the filter becomes dirty, pull
off the grill and lift out the filter.
Hand rinse in cold water under
low pressure. Let filter dry for 24
hours. Reposition dry filter and
snap grill into place.
REPLACEMENT
FILTER
Inspect Inlet Filter every
2 weeks to keep vacuum
running at peak performance.
Part No. 440009175
17