MRA 10963 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
1 Pair of holding plates
1 Traverse
4 Hexagon socket screw M5x10
4 Nuts M5
4 Washer 5mm
4 Oval-head screws M 5x16
4 Plastic washers 5mm
4 Rubber nuts M5
1 Edge protection strip, clamp sleeves
Fitting the screen to the motorcycle:
1. Fasten the holding plates using the original screws (do not yet tighten) and insert the
rubber nuts in the holes (P1).
2. Fasten the traverse with the hexagon socket screws M5x10, the washers and the nuts
M5 and now tighten the original screws (P2).
3. Position the MRA windshield as required and fasten it with the screws M 5x16 and the
plastic washers.
4. Pull the edge protection profile to the rear, open area of the screen, beginning from
the lining transition to the opposite side. Cut off the excess if necessary.
5. Push the clamp sleeves over the ends of the edge protection profile and press them
gently together with combination pliers so that the edge protection profile is
clamped.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
YAMAHA MT 09 (T / VT)
Article No..
--- Allen key 3, 4, 5mm
10963 Screw Wrench 8mm
11003
10998
11000
10999
10554
10635
10629
---
2
Required tools