How It Works - SCHEIBER 38.14720.50 Manual De Uso

We thank you for purchasing this product and we hope that it will bring you nothing but satisfaction.
Before connecting this device we recommend that you carefully read the below instructions.
The manufacturer cannot be held liable and declines any responsibility for damages or injuries due to
improper use or to failure to observe the warnings in this manual. The SCHEIBER company reserves the
right to alter the characteristics of the products in the interest of its customers.
It describes how to use and connect the product for the purpose for which it was designed.
After purchase, please make sure that the product is complete and not damaged ; when in doubt please
check with your dealer.
Please leave no part of the package within the reach of children or irresponsible adults.
If the product falls or suffers a severe impact, take it to a qualified person immediately to ensure that it is
not damaged.
Check (with the vehicle's distributor) what is the battery load capacity allowed by the alternator.
In order to have a correct mounting without overloading the alternator, and in order to protect the
auxiliary battery from premature aging, we recommend you to use batteries of the same capacity (+/-
20%)
Maximum capacity for each battery : 110Ah
Maximum load current : 40A
Connection between the electronic separator and the + batteries : with a 6mm² wire minimum.
Connection between the electronic separator and earth : with a 0.75mm² wire minimum.
Please protect each battery's "+" terminal with a fuse.
This device should be put in a place protecting it against any water spray risk and with terminals oriented
down.

If batteries are loaded from the alternator
The main battery should be loaded in first. When the voltage of this battery reaches 13V (± 0.1V), the
auxiliary battery is automatically connected in parallel. As long as the alternator works, both batteries are
loaded simultaneously.

If batteries are loaded from an external charger
If the charger is connected to the auxiliary battery's terminals, the working principle is the same than
during a load by alternator, the auxiliary battery being the first one to reload.

Uses 12V, without charger and alternator
Electric uses for vehicle's equipments (pumps, fridge, heating...) will be supplied from both batteries in
parallel. When the common voltage of these two batteries reaches 12.2V (± 0.1V), the main battery
(vehicle) is automatically disconnected. The consumption of the several uses will only be supplied by the
auxiliary battery.
Please note that below the threshold decoupling, the product consumption is very close to zero.
To avoid damaging the battery separator irreparably :
 don't use a of a destroyed battery.
 don't use a completely discharged battery; for example, after storage for a period of several
weeks. In this case, before starting the vehicle, check that the voltage at the battery's terminals
is up to 11V.
KEEP THIS BOOKLET FOR AN UNLIMITED TIME
CHARACTERISTICS

HOW IT WORKS

CAREFUL
- 3 -
EQ-11-44_01