Assembly Of The Filter Unit; Cleaning; Floor Nozzle; Dust Container With Filter Unit - Profi Care PC-BS 3037 A Manual De Instrucciones

Assembly of the Filter Unit

1. Place the coarse filter in the dust container. Please note
the recess on the edge of the dust container. Now push
the coarse filter down so that it is placed in the center of
the dust container.
2. Put the fine material filter (with the coloured fabric part
facing up) onto the coarse filter. Firmly press on the fine
material filter.
3. Then reattach the dust container to the handset. First,
place the dust container on top of the motor housing.
Now push the dust container down. The latch on the dust
container must audibly snap into place.
WARNING:
• Always disconnect the appliance from the power adapter before

cleaning!

• Under no circumstances should you immerse the motor housing
in water in order to clean it. Otherwise this might result in an
electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• The single components are not dishwasher-safe.
• Wipe the casing with a damp cloth.
• You can wipe the power adapter unit with a dry cloth.

Floor Nozzle

1. Disconnect the floor nozzle from the suction pipe.
2. Turn the floor nozzle
around, so that you
see the lower side.
Use a small coin or
any other tool to open
the latch. Direction of
rotation: Counterclock-
wise. Flip the cover
open.
3. Pull out the brush roller.
4. Remove threads and hair wound to the brush. Use
scissors, if required.
50
PC-BS3037A_IM
Outlet Filter
The appliance is also equipped with an exhaust filter. It is
located at the top of the motor housing.
CAUTION: You cannot remove this filter.
Cleaning
5. Assembly:
5.1 Put the brush roller, with the star-shaped recess
first, back into the compartment.
5.2 Insert the other end of the brush roller with the
square bearing into the recess underneath the
cover.
6. Close the lock of the brush roller.

Dust Container with Filter Unit

Please read the chapter "Maintenance" for cleaning of these
components.
• Clean the appliance as described and allow it to dry.
• For storage, use the previously mounted wall bracket or
carefully place the appliance on the floor.
• We recommend that you keep the appliance in the origi-
nal packaging if it will not be used for long periods.

Storage

27.05.19