Installation - Sammic HM-1000 Manual De Instrucciones

INSTALLATION

CONNECTING TO THE MAINS
Before you use your oven, check that the voltage shown
on the data label located on the face of the oven con-
firms with your mains supply. The mains lead is fitted
with a non-removable moulded-on 13 amp plug contain-
ing a 13 amp fuse. If the fuse requires replacing at any
time, the fuse cover should be removed using a small
screwdriver to lever it out. The old fuse should be
replaced by a 13 amp ASTA approved BS1362 fuse and
the fuse cover must be refitted before the plug is used
again.
If the plug supplied on the mains lead is not suitable for
the socket in your home, it should be cut off and dis-
posed of safety, or destroyed, to avoid any possible
shock hazard resulting from the plug being inserted into a
13 ampsocket elsewhere in hte house. A suitable
replacement plug should then be fittd as given below. (If
a 13 amp plug and socket are not used, the circuit sup-
plying the ovenshould contain a 13 amp fuse.)
If the fuse cover is lost or damaged, the plug must not be
used until a replacement is obtained. Replacement fuse
covers are available from Sanyo Service Centres. It is
important that the colour of the replacement fuse cover
corresponds with the coloured insert or as embossed in
words on the base of the plug.
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT The wires in this mains lead are coloured
in accordance with the following code:
Green-and-yellow: Earth. Blue: Neutral. Brown: Live
As the colours of the wires in the mains lead of this appli-
ance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
WARNING
(a) Do not adjust or repair microwave oven yourself. Do not operate the oven if it is dam aged,
until it has been repaired by a service enginer trained by the manufacturer.
(b) It is dangerous for anyone other than a properly qualified engineer trained by the manufac-
turer to carry out adjustments or repairs.
(c) If the power supply cord is damaged, it must be relaced by the manufacturer, as a specially
prepared cord is required.
(d) On no account remove or interfere with any parts or screws.
THIS COULD PROVE VERY DANGEROUS.
SAVE THESE INSTRUCTIONS
The wire which is coloured green-and-yellow must be
connected to the terminal in the plug which is marked
with the letter E or by the earth symbol
green or green-and-yellow.
The wire which is coloured blue must be connected to
the terminalwhich is marked with the letter N or coloured
black.
The wire which is coloured brown must be connected to
the terminal which marked with the letter L or coloured
red.
FUSE The appliance must be protected by a 13-amp
fuse, fitted to the 13-amp mains plug (BS1363).
POSITIONING THE OVEN
1. Install the oven on a flat, level surface sttong enough
to safely bear the weight of the oven.
2. Do not locate the oven near areas where heat and
moisture are generated as this may lower oven efficiency.
3. Covering the air vents may lead to the malfunction-
ing, therefore a minimum of 5 cm is required above, to
each side and to the rear of the oven.
4. This oven conforms to EEC Radio interference
Directive 87/308/EEC, however some interference may
occur if it is placed too close to a radio or TV, so keep
them as far apart as possible.
5. A minimum free space of 17 cm above the oven
should be present.
3
or coloured