Unpacking Inspection; Hard Disk Installation; Wiring Installation - Zodiac Security 559590435 Manual De Usuario

simple and intuitive graphical interface.
3.3 Installation Guide

3.3.1 Unpacking Inspection

Please inventory according to the packing list inside the box when you receive the
product.

3.3.2 Hard disk installation

Preparing for Installation:
You need a Phillips screwdriver.
Note: The number of drives supported by each model DVR subject to the corresponding
product specification sheet maximum hard disk capacity of 64TB.
Hard disk installation steps:
Open the screw on the side of the chassis , and open the the hard screw holes on the chassis
cover using screws to secure the hard disk in the inquiry or the hard disk bracket; Connected
hard drive data cable and power cord;
Cover chassis cover with the screws.
Precautions:
Select the hard drive manufacturer's recommended requirements for DVR hard drive.
After booting the system will automatically format the hard disk , the original data in the hard
disk may be lost completely .
Hard drive capacity and video parameters configuration will affect the total length of videos
saved, reference 7.2 reference calculation on the total capacity of the installed hard disk

3.3.3 Wiring Installation

Installation preparation:
Be ready to video cameras, monitors, video cable, network cable, mouse, and power lines.
Installation steps:
To rotate the level of DVR, the video input source to video input connector on the back of the
DVR;
DVR video output to display devices on the device-side;
If you want to use the network, please plug the network cable to the RJ45 interface;
Mouse with USB type you want, you can insert any of the front and back panel USB interface
connected to the DVR power.
Note:
If you need an external alarm device or platform, please refer to the Setup instructions related
content.
Power on the DVR should be in connection with all lines are connected.
When the power is connected, please note the power parameter.