Double Insulation - VITO PRO-POWER MD1700 SDS HEX Manual De Instrucciones

EN
deSCriPtion (FiG. 1)
1. Main handle
2. On/Off switch
3. Auxiliary handle
4. Lock/Unlock lever
5. Toolholder
6. Level indicator oil /oil filler
opening
7. Auxiliary handle clamping knob
StartinG
> For any intervention,
insertion of accessories...
in the machine, is required to be
turned off of the power socket.
20
> For your safety,
carefully read the information
contained herein safety
instructions.
This demolition hammer
is designed for chipping work
and demolition in hard materials.
1. Power supply
The demolition hammer
must be connected to a power
supply whose voltage is the
same indicated on the appliance
nameplate, ie 230-240V ~ 50Hz.

2. double insulation

This demolition hammer
has a double insulation.
Therefore, it is not necessary
to connect it to an outlet equipped
with grounding.
3. extension cable
When the work area is far from
the power source, use an extension
cord with sufficient sizing capacity.
The extension cord should be as
short as possible.
4. oil level
Before use, check the machine
oil level, looking through the oil
indicator. If the oil level is below
30 mm, remove the indicator
access cover and fill the oil tank
by adding 15W40 motor oil (see
section "Lubrication"). The breaker
oil level should be checked regularly
(preferably before each use).
5. auxiliary handle fixing
(FiG. 2 and 3)
When using the breaker, always
hold firmly the machine with both
hands, one on the main handle and