Troubleshooting; Before Returning For Repairs - Schumacher Electric CR1 Manual Del Usuario

12. TROUBLESHOOTING

PROBLEM
All three LEDs come on for
2 seconds, then turn off.
CHARGING
orange) LED is flashing.
CHARGED
LED is flashing.
The charger will not
turn on when properly
connected.
I cannot select a 6V or
12V setting.

13. BEFORE RETURNING FOR REPAIRS

If these solutions do not eliminate the problem, or for more information
about troubleshooting, contact customer service for assistance:
or call 1-800-621-5485, Monday-Friday 7:00
For REPAIR OR RETURN, contact Customer Service at 1-800-621-5485. DO
NOT SHIP UNIT until you receive a RETURN MERCHANDISE AUTHORIZATION
(RMA) number from Customer Service at Schumacher Electric Corporation.
POSSIBLE CAUSE
The charger is plugged into
an AC outlet.
Charger is in abort mode.
(yellow/
The battery's charge is
(green)
80% or higher.
AC outlet is dead.
Poor electrical connection.
Battery is defective.
The charger is equipped
with Auto Voltage Detection,
which automatically detects
the voltage and charges the
battery.
services@schumacherelectric.com
www.batterychargers.com
am
• 10 •
REASON/SOLUTION
No problem; this is normal.
Unplug the charger from
the AC outlet, wait a few
moments and plug it back in.
No problem; this is normal.
Check for open fuse or
circuit breaker supplying the
AC outlet.
Check power cord and
extension cord for a loose
fitting plug.
Have the battery checked.
No problem; this is normal.
to 5:00 CST
pm