Assembly Instructions; Operating Instructions; Important - Schumacher Electric CR1 Manual Del Usuario

6v/12v cargador universal para juguetes montar-en
Ocultar thumbs Ver también para CR1:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9.

ASSEMBLY INSTRUCTIONS

9.1 Remove all cord wraps and uncoil the cables prior to using the battery charger.

10. OPERATING INSTRUCTIONS

BATTERY INFORMATION
This charger can be used with 6 and 12V batteries; it automatically detects your
battery type.
CHARGING
NOTE: Examine the battery for excessive wear, cracks, bulging or damage each
time you charge it. If damage is detected, do not charge the battery; replace it
immediately. If the battery is hot, allow it to cool before charging.
1. Select the proper output cable by matching the output cable connector to the
vehicle's battery connector.
2. Connect the battery, following the Using the Quick-Connect Cable
Connectors section.
3. Connect the charger to an electrical outlet. The POWER
4. If you've connected everything correctly, the CHARGING
LED should light, indicating that the charger is charging. The POWER
(red) LED will remain lit.
5. When the battery is fully charged, the
IMPORTANT: This charger does not have an ON/OFF switch. ON and OFF are
controlled by plugging in the charger to the AC wall outlet. The charger will not
supply current to the connector until a battery is properly connected.
USING THE QUICK-CONNECT CABLE CONNECTORS
1. Connect the output cable assembly to the charger. Make sure to place the
charger on a dry, non-flammable surface.
2. With the charger disconnected from the wall outlet, connect the supplied harness
assembly by connecting the blue connector to the blue connector on the end of
the charger cable. Connect the other end of the cable assembly to the battery.
NOTE: See Replacement Parts/Accessories for more connector information.
NOTE: Never connect the output cable assemblies together for use in other
applications, such as external battery or other power source charging, or to extend
the output cable length, as reverse polarity and/or overcharge conditions will occur.
CHARGED (green) LED will pulse.
• 8 •
(red) LED will light.
(yellow/orange)

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido