Charging System; Maintenance; Warranty - Adalit L3000 Manual De Usuario

5 Charging System

When the torch is placed on the charger, the light
turns off automatically (if the light is on). Charging of
the torch starts when the green LED on the charger
changes to red. An automatic reset takes care of
loading the batteries for max. 4h with highest light
intensity. The maximum charging time is 9 hours.
The time that appears after the letter
indicates the available burning time at
high intensity in the moment the torch is
taken from the charger and put into use.
At the end of charge, the display swit-
ches off and a letter "F" (full) followed by
the avalaible burning time will appear
on the display every 15 seconds.
If the charger is damaged, the display
shows the following error 'E0:00'. But
thanks to the intelligent circuit board the
torch keeps protected from the possible
damages due to a faulty charger.

6 Maintenance

Cleaning
• Clean exclusively with a soft cloth using a neutral
PH detergent diluted in warm water. Do not use
alcohol or other chemical solvents. Do not sub-
merge the torch into water.
• Do not open the torch in hazardous areas.
• IN ORDER TO GET THE MAXIMUM PER-
FORMANCE AND LIFE SPAN OF THE
BATTERY , A COMPLETE DISCHARGE/
CHARGE CYCLE SHOULD BE DONE AT
LEAST ONCE PER MONTH.

7 Warranty

Lamp L3000 has a warranty of 2 years against any
fabrication default, for use under normal conditions
and in accordance with the present instructions. It
does not include the battery nor the LEDs which are
guaranteed for 1 year.
Clip replacement L3.480
1. Remove the two
upper screws
2. Remove the clip
3. Take out the two nuts
LED Engine Replacement
1. Unscrew the screw
ref. L3.49
2. Remove the closing
ring and the protection glass
ref. L3.10
3. Take out the LED engine
ref. L3.20
4. Disconnect the LED engine
Battery and/or
Protection Fuse Replacement
1. Unscrew the torch body
closing screws ref. L3.530
2. Separeate the torch body
from the torch ref. L3.50
3. Remove the fuse from
its position ref. WL.117