As Sembl I Ng Yo U R Ble Nd E R - Oster BLSTCAG4551R Manual De Instrucciones

AS SEMBL I NG YO U R BLE ND E R

1. Turn your jar upside down so smaller opening is facing up.
2. Place sealing ring over small jar opening.
3. Turn blade assembly upside down and place it over small jar opening.
4. Tighten jar's threaded bottom cap.
ADJUSTING THE JAR
a. To adjust jar positioning, carefully place assembled jar into motor base, with
handle and jar stopper in front of right break.
b. Using jar handle, turn jar to the left as much as possible. This will ensure bottom
of jar is properly adjusted.
c. To operate blender, place assembled jar into motor base with jar stopper against
flat side of motor base break. If jar stopper is not against flat side of the right
break, lift jar and replace stopper against flat side of the left break. Put jar firmly in
place and operate blender.
d. To remove jar, lift it straight up. (If jar cannot be removed easily, gently twist it from
side to side and lift it up; do not turn.) If bottom of jar cannot be released by hand,
place assembled jar into motor base, with jar handle in front of the left side break.
Using handle, turn jar to the right until bottom of jar is released. Do not attempt to
place or remove jar from motor base while motor is running.
ALWAYS HOLD JAR WITH ONE HAND WHILE POWERING ON YOUR
BLENDER!
Angry Beavers_18ESM2 (LA).indd 4
En g lish- 4
7/12/18 9:27 AM