Stiga BL 2.6 E Manual De Instrucciones página 103

SAFETY WAR NINGS
equipment such as dust mask,
non-skid safety shoes, hard
hat, or hearing protection used
for appropriate conditions will
reduce personal injuries.
c) Prevent unintentional start-
ing. Ensure the switch is in
the off-position before con-
necting to power source,
picking up or carrying the
tool. Carrying power tools
with your finger on the switch
or energising power tools that
have the switch on invites ac-
cidents.
d) Remove any adjusting key
or wrench before turning
the power tool on. A wrench
or a key left attached to a ro-
tating part of the power tool
may result in personal injury.
e) Do not overreach. Keep
proper footing and balance
at all times. This enables bet-
ter control of the power tool in
unexpected situations.
f) Dress properly. Do not wear
loose clothing or jewellery.
Keep your hair, clothing
and gloves away from mov-
ing parts. Loose clothes,
jewellery or long hair can be
caught in moving parts.
4) Power tool use and care
a) Do not force the power tool.
Use the correct po wer tool
for your application. The
correct po wer tool will do the
job better and safer at the rate
for which it was designed.
b) Do not use the power tool
if the switch does not turn
it on and off. Any power tool
that cannot be controlled with
the switch is dangerous and
must be repaired.
c) Disconnect the plug from
the power source before
making any adjustments,
changing accessories, or
storing power tools. Such
preventive safety measures
reduce the risk of starting the
power tool accidentally.
d) Store idle power tools out
of the reach of children
and do not allow persons
unfamiliar with the power
tool or these instructions
to operate the power tool.
Power tools are dangerous in
the hands of untrained users.
e) Maintain
Check for misalignment
or obstruction of moving
parts, breakage of parts
and any other condition that
may affect the power tool's
operation. If damaged, have
the power tool repaired be-
fore use. Many accidents are
caused by poorly maintained
power tools.
f) Keep cutting tools sharp
and clean. Properly main-
tained cutting tools with sharp
cutting edges are less likely to
become jammed and are eas-
ier to control.
g) Use the power tool, acces-
sories and tool bits etc.
in accordance with these
instructions, ta king into
account the working con-
ditions and the work to be
performed. Using the power
tool for operations other than
those intended could result in
a hazardous situation.
5) Service
a) Have your power tool ser-
viced by a qualified re pair
person using only identical
EN
power tools.
5