Schulz AGE 250 Manual De Instrucciones página 54

1. Fuel (RGG 25 model)
ATTENTION:
duct it is essential to fi ll with fuel + two-stroke oil. Always switch the product off and let it cool down, before
refuelling it. Follow the instructions bellow:
1.1. How to mix fuel
• Pay attention to the mixture. The recommended mixing ratio for petrol:oil is 40:1 .
• It is necessary to use regular gasoline for the mixture. Avoid gasoline with additives because they are not
compatible with two-stroke oil.
• Using an anti-oxidant added quality oil expressly labeled for air-cooled 2-cycle engine use. Do not use mixed
oil.
• Poor quality oil or gasoline can damage the engine's O-rings, fuel lines or fuel tank.
• The engines are lubricated by oil specially formulated for air-cooled 2-cycle gasoline engine use.
• Measure out the quantities of gasoline and oil to be mixed;
• Put some of the gasoline into a clean, approved fuel container;
• Pour in all of the oil and agitate well;
• Pour in the rest of gasoline and agitate again for at least one minute. As some oils may be diffi cult to agitate
depending on oil ingredients, suffi cient agitation is necessary for the engine to last long. Be careful that,
if the agitation is insuffi cient, there is an increased danger of early piston seizing due to abnormally lean
mixture.
• Indicate the contents on outside of container for easy identifi cation. To avoid mixing up with gasoline or
other containers. Always store gasoline in a container approved for fl ammable liquids.
1.2. Fueling the equipment
• Make sure to stop the engine and allow it cool before refueling the equipment;
• Do not smoke or place hot object near fuel and do not refuel a hot engine or refuel a running engine;
• Untwist and remove the fuel cap. Rest the cap on a dustless place;
• be sure to suffi ciently agitate the mixed gasoline in the container. Put fuel into the fuel tank to 80% of the
full capacity. Avoid spilling fuel;
• Fasten the fuel cap securely and wipe up any fuel spillage around the unit;
• Move at least 10 feet (3 meters) away from the fueling point before starting the engine.
IMPORTANT
and the inside edge of the tank to allow for expansion.
2. Starting and stopping the tool
ATTENTION:
cutting head in use does not touch the ground or any objects.
This product is not supplied with fuel in the engine. Before operating this pro-
Do not overfi ll the tank. Leave a minimum 5mm of space between the top of the fuel
Before starting the tool, place the product on a fl at, stable surface. Ensure that the
54