Inserting The Bobbin - Kenmore 385.1 911 2 Manual De Instrucciones

• Inserting the bobbin
_i_ End of thread
Notch
_3_ Notch
_4_ Threading diagram
[1!_ Place a bobbin in the bobbin holder with the thread
running off counterclockwise.
[2J Guide the thread into notch _2_ on the front side of the
bobbin holder. Draw the thread to the left, sliding it
between the tension spring blades.
[B] Continue to draw the thread lightly until the thread slips
into notch _3_. P ull out about 6" (15.0 cm) of thread.
[i_i]Attach the hook cover plate. Check the threading by
referring to the diagram _4_ shown on the hook cover plate.
%
%
%
22