Tabla de contenido
Publicidad
inserting
the bobbin
[] Place a bobbin in the bobbin holder with the thread
running off counterclockwise,
End of thread
[] Guide the thread into the first notch (_) on the front
side of the bobbin holder. Draw the thread to the left,
sliding it between the tension spring blades.
_) First notch (_
[] Continue to draw the thread lightly until the thread
slips into the second notch _ . Pull out about 6"
(15 cm) of thread
(_ Second notch
[] Attach the hook cover plate. Check the threading by
referring to the chart shown on the hook cover plate.
(_ Threading chart
[]
[]
[]
d
\
@
36
Publicidad
Tabla de contenido
