Montaggio; Assembly Of The Base; Assembly Of The Accessories; Assembly Of The Workbench Extension - Fox F36-528A Manual De Instrucciones

WARNING!
BE SURE THAT THE SAW IS SWITCHED OFF AND DISCONNECTED FROM ANY
CURRENT SOURCE BEFORE ASSEMBLING IT OR CARRYING OUT ANY ADJUSTMENT
OR MAINTENANCE TASK.

ASSEMBLY OF THE BASE

Put the workbench (1) Fig. 1 on a plane surface.
•
Assemble the feet (18) under the workbench (1) without tightening the screws Fig. 2.
•
Warning: You must correctly fix the switch to the hind leg on the left (19) Fig. 1.
Slightly tighten the leg backing strips (24) to the mitre saw's legs (18 and 19).
•

ASSEMBLY OF THE ACCESSORIES

Tighten the aspiration coupling (14) to the chip pan's bottom side (17) by means of 4 screws (32) Fig. 3.
•
Place the 4 rubber feet (25) on the mitre saw's legs Fig. 2.
•
Assemble the anchor plates (22) on the inner side of the hind leg (18) of the table saw with 4 screws (33)
•
Fig. 4.
Turn the mitre saw upside down and position it on its legs.
•
Insert the switch group (11) in the foot inlay (19) designed for this purpose and tighten firmly with 2 screws
•
(34) Fig. 6.
Assemble the transport handle (16) on the front legs with 2 screws (35) Fig. 6.
•
Warning: The handles (16) are moving parts and must lower automatically!
Tighten the aspiration pipe holder (29) in the workbench's back side (1) with 2 screws (36) Fig. 5.
•
Adjust the machine's base and tighten correctly all the screws that you have used before during assembly.
•
Assemble the two locking levers (21) Fig. 6 to block the rip fence's slide rail on the front side of the
•
workbench.
Warning: Screw the levers (21) but not wholly, otherwise the rip fence (7) cannot be fixed.
Assemble the tool hanger (28) Fig. 6 on the side of one of the legs of the saw.
•

ASSEMBLY OF THE WORKBENCH EXTENSION

Assemble the workbench extension (10) in the workbench's backside (1) with 2 screws, but do not tighten
•
them.
Place the workbench's extension bearings (26) Fig. 1 and fix them firmly using the holes designed for this
•
purpose.
Align the workbench extension (10) with the workbench (1), then tighten firmly all the screws.
•

USE OF TRANSPORT WHEELS

Lift the machine from the backside (a) Fig. 8 and push backwords (b) the wheels (15) to transport it.
•
Lower the table saw (c) Fig. 8.
•
Easily move or transport the mitre saw by using the handles (16) Fig. 6.
•
Warning: After having moved the saw, the transport structure with wheels (15) must be replaced in its initial
position in order to ensure a stable position of the table saw: to do this follow these instructions in reverse order.

ASSEMBLY / REMOVAL OF THE PROTECTIVE CAP

Position the protective cap (2) Fig. 7 on the riving knife (5) and let the screw (37) pass through the riving
•
knife's hole (45).
Do not tighten the screw (37) wholly; the protective cap must rise and lower freely.
•
Fix an end of the aspiration pipe (13) Fig. 1 to the coupling (14) Fig. 3 and the other end to the protective
•
cap's pipe (2).
Connect a suitable aspiration device to the end of the coupling.
•
Warning: the protective cap (2) must be lowered on the workpiece before starting cutting.
EN

MONTAGGIO

30