General Features; Setting The Clock; Reset Button; Clock Display - Philips AQ 6688 Instrucciones De Manejo

GENERAL FEATURES

Reset button

Should you receive external interference e.g. static electricity
from carpets, thunderstorms, etc. which affects the display and
electronic functions of your set, the reset button allows you to
clear all data (e.g. tuning step, presets) from your set and to
start up again.
• Use a ball point pen to press the RESET button, found on
the back of the cassette door.
Locking
This button helps you to prevent any of the other front panel
controls from being accidentally pressed when you are
listening to the radio or when you are not using the radio.
1 Press the LOCK button
™
appears in the display when LOCK is activated.
2 To deactivate the LOCK function, press LOCK again.
™ disappears from the display.
AQ 6688 /00 - page 5

SETTING THE CLOCK

CLOCK DISPLAY

The time is displayed using either the 12 or 24-hour clock
system. The seconds are synchronized with the flashing colon
':' second by second, and also by the 12-segment analogue
clock display, where each segment represents 5 seconds.
1 In the time mode, press ENTER.
™ The clock digits will flash for 5 seconds.
2 To set the hour/ minutes for the clock time, press
while the display is still flashing.
™ With your finger held down on
, the hour will increase
HR
steadily as a number from 1-12 or 0-23. Release
you reach the approximate time setting.
™ With your finger held down on
, the minutes will
MIN
increase rapidly and continuously. Press briefly and
repeatedly if you need to adjust the minutes slowly.
3 Press the ENTER button a second time to confirm the time
setting.
™ The clock digits will stop flashing.
or
HR MIN
when
HR
5