Wireless Hand-Held Microphone
These instructions are intended for users without
any specific technical knowledge . Please read these
instructions carefully prior to operating the unit and
keep them for later reference .
All operating elements and connections de-
scribed can be found on the fold-out page 3 .
1 Operating Elements
1.1 Fig. 1: Hand-held microphone
1 Microphone cartridge; to insert batteries,
unscrew the cartridge (figs . 2 to 4)
2 LC display; shows the transmission channel
and the charging status of the batteries during
operation
3 Cap for the control part; remove the cap for
operation (fig . 5)
4 Power switch
1.2 Figs. 2 to 4: Inserting batteries
(microphone cartridge unscrewed)
5 4-pole contact, each on the microphone car-
tridge (fig . 2) and on the handle (fig . 3);
prior to assembling the microphone cartridge
and the handle, interconnect the contacts
6 Lock for the battery holder (7);
to unlock the holder, push the lock to the rear
in arrow direction
7 Battery holder for two 1 .5 V batteries of size
AA (R6)
1.3 Fig. 5: Control part
(cap removed)
8 Key SET
with the unit not locked:
to call and to exit the adjusting modes for
channel / sensitivity/ lock function
☞
chapters 5 .1, 5 .2 and 5 .3 .1
with the unit locked:
to call and to exit the adjusting mode for
the lock function
9 Key for channel selection "down" (in the
channel adjusting mode), to reduce the sensi-
tivity (in the sensitivity adjusting mode), and to
deactivate the lock function (in the lock mode)
10 Key for channel selection "up" (in the chan-
nel adjusting mode), to increase the sensitivity
(in the sensitivity adjusting mode) and to acti-
vate the lock function
☞
chapter 5 .3 .2
2 Important Notes
This unit corresponds to all relevant directives of
the EU and is therefore marked with
•
The unit is suitable for indoor use only . Protect
it against dripping water and splash water, high
air humidity and heat (admissible ambient tem-
perature range 0 – 40 °C) .
•
For cleaning only use a dry, soft cloth; never
use chemicals or water .
•
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it
is not correctly operated or not repaired in an
expert way .
If the unit is to be put out of operation
defini tively, take it to a local recycling
plant for a disposal which is not harmful
to the environment .
3 Applications
In combination with the 2-channel multifrequency
re ceiver TXS-891 from IMG STAGELINE, this
dynamic hand-held microphone with integrated
multifrequency transmitter creates a wireless
audio transmission system . Within the UHF
frequency range of 863 – 865 MHz, the transmis-
sion channel can be se lected as desired among
16 channels .
The microphone is supplied with a micro-
phone case, a microphone holder and 7 push-on
caps of different colours .
3.1 Conformity and approval
of the wireless microphone
Herewith, MONACOR INTERNATIONAL declare
that the wireless microphone 891HT complies
with the directive 2014 / 53 / EU . The EU declara-
tion of conformity is available on the Internet:
www .imagestageline .com
This wireless microphone is licence-free and
generally approved for operation in EU and EFTA
countries .
.
7