Operating Elements And Connections; Safety Notes - Monacor SR-103DMX Manual De Instrucciones

DMX Signal Splitter
These instructions are intended for users with
basic knowledge in DMX control . Please read
the instructions carefully prior to operation and
keep them for later reference .
1 Operating Elements
and Connections
1 Mains cable for connection to a mains socket
(230 V/ 50 Hz)
2 POWER LED
3 DMX signal input
pin 1 = ground, 2 = DMX−, 3 = DMX+
4 DMX signal outputs
pin 1 = ground, 2 = DMX−, 3 = DMX+

2 Safety Notes

This unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The unit uses dangerous mains
voltage . Leave servicing to skilled
personnel only . Inexpert handling
or modification of the unit may
result in electric shock .
•
The unit is suitable for indoor use only . Pro-
tect it against dripping water and splash
water, high air humidity, and heat (admissible
ambient temperature range 0 – 40 °C) .
•
Do not place any vessel filled with liquid on
the unit, e . g . a drinking glass .
•
Do not operate the unit or immediately dis-
connect the plug from the mains socket
1 . if there is visible damage to the unit or to
the mains cable,
6
1
•
•
•
•
.
•
DMX IN
3
2 1
2
3
2 . if a defect might have occurred after the
unit was dropped or suffered a similar
accident,
3 . if malfunctions occur .
In any case the unit must be repaired by
skilled personnel .
A damaged mains cable must be replaced by
skilled personnel only .
Never pull the mains cable when disconnect-
ing the mains plug from the socket, always
seize the plug .
For cleaning only use a dry, soft cloth; never
use chemicals or water .
No guarantee claims for the unit and no
liability for any resulting personal damage
or material damage will be accepted if the
unit is used for other purposes than originally
intended, if it is not correctly connected or
operated, or if it is not repaired in an expert
way .
Important for U . K . Customers!
The wires in this mains lead are coloured in
accordance with the following code:
blue = neutral
brown = live
As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals
in your plug, proceed as follows:
1 . The wire which is coloured blue must be
connected to the terminal in the plug
which is marked with the letter N or
coloured black .
2 . The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red .