Cleaning The Unit; Dmx Control - IMG STAGELINE STROBE-15LED Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
If the display already shows an address on
the display, this address can directly be
changed with the button UP or DOWN.
The indication keeps flashing until the button
ENT is pressed to confirm the adjustment.
2) Confirm the adjustment with the button ENT.
The indication stops flashing and the unit is in
the DMX control mode. The reception of control
signals is indicated by a flashing point behind
the letter . If the display shows the indication
instead of the address, the unit is in the
DMX control mode but it does not receive any
control signals.

6.2.3 DMX control

The stroboscope can only be operated via the DMX
controller when it is in the DMX control mode. In the
DMX control mode the display shows the start
address (
...
with the DMX control mode adjusted, no DMX
control signals are received.
If the display shows another operating mode,
press the button FUNC repeatedly until the address
is shown and press the button ENT to confirm.
The following table shows the functions of the DMX
control channels and the corresponding DMX val-
ues:
DMX
Function
value
channel 1: brightness
brightness 0 % (light off) → 100 %
0 – 255
for "constant light" and "stroboscope"
(if channel 2 = value 0 ... 200)
channel 2: operating mode
0
constant light
stroboscope
1 – 200
flash frequency low → high
music control
like
201 – 220
like
221 – 255
(
chapter 6.1.1, paragraph b)
Please observe the important note in chapter
6.1.1!
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
). When the display shows
®
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may

7 Cleaning the Unit

The plastic pane in front of the LEDs should be
cleaned at regular intervals from the outside,
depending on impurities caused by dust, smoke or
other dirt particles. Only this will ensure that the
light is radiated at maximum brightness. Prior to
cleaning, disconnect the mains plug from the
socket. Only use a soft, clean cloth and a mild
detergent. Take care that no liquid penetrates the
inside of the unit. Then wipe the plastic pane dry.
For cleaning the other parts of the housing, only
use a dry, soft cloth, never use any chemicals or
water.
8 Specifications
Light source: . . . . . . . three 5 W LEDs
Power supply: . . . . . . 230 V~ / 50 Hz
Power consumption: . 20 VA
Ambient temperature: 0 – 40 °C
Dimensions: . . . . . . . 260 × 90 × 85 mm
Weight: . . . . . . . . . . . 1.2 kg
Subject to technical modifications.
GB
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

38.5990

Tabla de contenido