O
perating Your Dryer
5. Close the Door.
Before you close the door, make sure fabrics are
properly loaded and not caught in the door opening.
6. Select the Drying Cycle you want.
You can choose a cycle by turning the program control
knob until the required program reaches to its indicator.
If you press START/PAUSE button without choosing any
cycle, the dryer will proceed with the COTTON program.
[Please refer to following Cycle Selection table (page 14)
for the detailed information]
7 . Press the Start button.
You can hear the drum turning.
8. After operation is completed, open the
door and remove the laundry.
Be careful! Drum inside could be still hot.
(Operation time varies depending on your cycle
selection or options.)
9. Clean the lint filters and
empty water container.
The lint filter should be cleaned after each load.
10. Turn off the Dryer.
Press the power button.
CAUTION
• Be careful the filter is not turn or damaged
when using a vacuum cleaner. If there is a
little residue buildup on filter, you can scrub
lint screen with the brush to remove.
• If you want to open the door while dryer is
operating, please press the START/PAUSE
button first, wait until drum completely
stops and then open the door.
16
F
Select the
desired
cycle.
Take out
the laundry.
Clean the
door lint
filter.