Warranty And After-Sales Service - ROBLIN CONFIDENCE CLEAN-R Manual De Istrucciones

• Clean the bodywork regularly using non-abrasive detergent products and a slightly damp sponge.
• To renovate external stainless steel parts (at intervals of one year minimum), it is preferable to use the product ref.112.0172.941
• Never use soaked sponges or rags..
• Do not insert any object, or your hands, into the opening serving for the extraction of the air.
• Clean the inside of the extraction body once per year.
• Check the flow of stale air every 6 months.
• Observe local regulatory requirements covering the extraction of stale air.
• It is essential to clean anti-grease filters in a dishwasher at a maximum temperature of 50°C, once per month or according
to the indications on the order (see order page). Allow the filters to dry in the open air. These filters have a service life of 10
years.
• If your hood is equipped with washable anti-odour filters
other kitchen utensils) every 2 months and dried by the dishwasher or in the open air for approximately 30 minutes.
• Once washed and dried, reactivate the washable anti-odour filters by placing them in an oven for 10 minutes at 100°C maxi-
mum. Cleaning of the washable anti-odour filters should systematically be accompanied by cleaning of the anti-fat filters.
• Active charcoal
hours per day. Or according to the indications of the order (see the order page). Replacement of the active charcoal anti-odour
filters should systematically be accompanied by cleaning of the anti-fat filters.
R
CLEAN-
• The ultraviolet bulbs have a life expectancy of approximately 6000 hours. The life cycle of the clean-air filters (catalysts) fol-
lows that of the ultraviolet lamps.
• The replacement of an ultraviolet bulb (every 3 years) should systematically be accompanied by the replacement of the asso-
ciated clean air filter.
• The replacement of faulty LEDs should only be done by a certified professional specialist.
GB
IF AN ELECTRIC COMPONENT IS DAMAGED IT CAN ONLY BE REPLACED BY A REPAIR SHOP APPROVED BY THE MANUFAC-
• In the event of faulty operation notify your installer who will check the appliance and its connection.
• Disconnect the appliance completely.
• Always require the use of genuine spare parts (non-compliance with this requirement can compromise the safety of the ap-
pliance).
• When ordering spare parts, quote the serial number of the appliance (see on the page opposite) on the plate located inside
the hood.
• Only the purchase invoice of the appliance can serve as proof for the implementation of the contractual warranty (this war-
ranty does not cover consumables such as: lighting, filters, LEDs, etc.).
anti-odour filters: (active charcoal filter (black appearance) and washable charcoal filter (similar appearance to the anti-grease filter but thicker and with a smaller circu-
(3)
10
Avoid fire risk by cleaning the hood according to the maintenance instructions :
Turn the hood off before any maintenance operation or electrical work. Wear gloves.
anti-odour filters need replacement at least every 3 months, or more often if the hood is used more than 3
(3)

WARRANTY AND AFTER-SALES SERVICE

TURER BECAUSE SPECIAL TOOLS ARE REQUIRED.
MAINTENANCE
, they must be cleaned in a dishwasher at high temperature (without
(3)
mference)) are always placed after the anti-grease filter; this is the first one visible.