Product Description; Getting Started; Baby Bottle Warmer - Topcom Baby Bottle Warmer 301 Manual De Usuario

TOPCOM Baby Bottle Warmer 301
• Only use baby bottles that have been approved for boiling.
• For hygienic reasons, you should change the water every time you used the appliance.
• Food should not be heated for too long.
2

Product description

2.1 Accessories
1. Cover
2. Juicer
3. Food cup
4. Warming basin
5. Power LED
6. Thermostat
7. Mains power connector
3 Installation
• Plug the end of the power cord into the 230V outlet.
The wall outlet for the power supply must be close and accessible.
4

Getting started

4.1

Baby Bottle Warmer

• Remove every accessory from the unit.
• Pour the 100ml water into the warming basin
• Put the baby bottle with milk (240 ml) into the warming basin
• Turn the thermostat t
• The water will warm up and this will heat the baby bottle.
• After 10 minutes, the milk will be about 40°C.
• Remove the bottle from the warmer and check the milk temperature.
• Disconnect the power after use. Let the device cool down and remove
the water.
Changing the thermostat temperature will influence the warming
time. The higher the temperature, the quicker the bottle will warm.
– 240ml, starting from fridge temperature (7°C) will take +/- 10 minutes (thermostat 70°C).
– 150 ml, starting from room temperature (20°C) will take +/- 7 minutes (thermostat 70°C).
Rol the bottle between your two hands to spread the temperature in the bottle. Do not shake!
Always check that the food temperature by testing some on the back of your hand.
4
o 70°C.
6
1
2
3
4
5
6
.
4
.
4
TOPCOM Baby Bottle Warmer 301
7
100ml