Operation - Ryobi RYAC800 Manual Del Operador

WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced. Please contact customer service or
a qualified service center for assistance.
APPLICATIONS
You may use this product for the purpose listed below:
 Removing snow from desired areas such as driveways
and sidewalks
WARNING:
Always disconnect snow shovel from power supply when
you are assembling parts, making adjustments, cleaning,
or when not in use. This will prevent accidental starting
that could cause serious personal injury.
ADJUSTABLE FRONT HANDLE
See Figure 2.
The angle of the front handle can be adjusted 180°.
 Disconnect the snow shovel from the power source.
 Set the unit on a flat surface and turn the knob counter-
clockwise to loosen the handle.
 Adjust the handle as desired.
 Turn the knob clockwise until the handle is securely
tightened.

OPERATION

ADJUSTING TELESCOPING POLE
See Figure 3.
 Rotate the threaded collar counterclockwise to loosen.
 Push poles towards each other to shorten the pole or pull
away from each other to lengthen the pole.
 When the desired length is achieved, rotate the threaded
collar clockwise to secure.
CONNECTING TO POWER SUPPLY
See Figure 4.
This product is designed with a cord retainer that prevents
the extension cord from being pulled loose while using.
 Form a loop with the end of the extension cord.
 Insert loop portion of extension cord through opening in
the bottom of the rear handle and place over cord retainer.
 Slowly pull loop against cord retainer until the slack is
removed.
 Plug product into extension cord.
NOTE: Failure to remove all excess cord slack from extension
cord retainer could result in plug loosening from receptacle.
STARTING/STOPPING THE SNOW SHOVEL
See Figure 4.
To start the motor:
 Connect the snow shovel to power supply.
NOTICE:
Always secure extension cord to unit by using cord
retainer. Failure to use cord retainer may result in damage
to the unit and/or extension cord.
 Place your thumb on the lock-out button.
 Fully depress the switch trigger.
 Release the lock-out button.
To stop the motor:
 Release the switch trigger.
OPERATING TIPS
See Figure 5.
WARNING:
Never use snow shovel on frozen lakes, rivers, or similar
surfaces. Death or serious injury could occur if the ice
breaks.
WARNING:
Never use the snow shovel on a rooftop or other unstable
surface, which can result in death or serious personal
injury.
8 — English