Error Messages - Garant 380865 1 Manual De Instrucciones

3.4

Error messages

DE
The display Err.1 appears, if the sensor is not plugged in or is defective.
Err.2 is displayed, if the surrounding fields are so high during ZERO-SET button press, that zeroing
cannot be done.
EN
Error Display
The Tesla meter displays the following Err.1 or Err.2 messages according to the contents of troubles.
FR
IT
How to reset
Please reset when the value on the display becomes unstable and/or the products can not be
properly operated by button.
ES
How to reset:
Take out the battery, and then remove AC adapter, or cable in case the connection by USB.
u
Leave the product for about 5 seconds.
u
Put the power on and make it sure that the product works properly.
u
CZ
Maintenance
1. Replacing the battery
If the battery is consumed during use, the battery replacement, mark illumi nates in the display.
PL
Then replace the battery with new four manganese or alkali dry cells (R-6). (which shall be after
recharged in case of recharge able battery)
RU
2. How To Replace Probe
When the probe is worn or damaged or "Err.1" is shown on the display, re place it with the
separately available measuring probe (Type TM-801 PRB). It may be used without calibration.
ZH
3. Cleaning the Tesla meter main unit and probe
If they are dirty excessively, wipe them with cloth dampened with water or cloth containing a
small amount of sufficiently diluted neutral detergent.
Then wipe them with dry cloth completely. Never use benzene, thinner or chemical cloth, that
will damage the surface.
28
This is displayed when the probe is not inserted. If this is displayed when it is
inserted, the probe is faulty. Replace it with a new one.
For the replacement methed. refer to Lhe section of maintenance in page 11.
This is displayed when the ZERO/RESET switch is pressed. If a strong magnetic
source exists nearby, move it away and press the ZERO/RESET switch. If the
error is displayed again, take necessary corrective action.
Changing the battery icon