Troubleshooting - Oregon LM300 Manual De Instrucciones

Troubleshooting

Use this table to see possible solutions for possible problems with the lawn mower If these suggestions
do not solve the problem, see "Warranty and Service"
SYMPTOM
Tool fails to operate
Motor starts and
stops immediately
Tool functions
intermittently
Garden product
leaves ragged
finish and/or Motor
labours
14
Troubleshooting
POSSIBLE CAUSE
Possible clogging
Battery not fully charged
Battery not inserted
(properly)
Grass too long
Motor protector has
activated
Battery too hot/cold
Safety key not inserted
correctly/fully
There is a short delay in
the motor starting after
engaging the safety
button switch
Battery not fully charged
Isolator key not inserted
correctly/fully
Battery not inserted
(properly)
Battery too hot/cold
Internal wiring of garden
product damaged
Motor protector has
activated
Height of cut too low
Cutting blade dull
Possible clogging
Blade fitted upside down
RECOMMENDED ACTIONS
Remove battery, remove safety key
Clear obstructions
Check underneath the garden product and clear out as
necessary (always wear gardening gloves)
Charge battery
Properly insert battery
Increase height of cut and tilt garden product to reduce
starting load
Allow motor to cool and increase height of cut
Allow to cool/warm
Insert safety key correctly
Hold safety button for 1 – 3 seconds before engaging
switch lever to start motor
Charge battery
Insert safety key correctly
Properly insert battery
Allow to cool/warm
Contact service agent
Allow motor to cool and increase height of cut
Increase height of cut
Replace the blade or sharpen the blade
Remove battery, remove safety key
Check underneath the garden product and clear out as
necessary (always wear gardening gloves)
Remove battery, remove safety key
Refit blade correctly
Lawn Mower Model LM300